Driver card for use toghether with MGP panel decoder and Signal decoder.

This driver card handle 12 standard LED.
LEDs are connected directly to the card (without any resistors - brightness is controlled from the decoder).

Can be used to drive e.g. railroad signals like e.g. the Swedish signals from JECO. Signals should have common + (common anode) and any resistor shall be removed.

Several driver cards can be connected to the same decoder in serial.

The driver card is connected to the decoder with a standard servo extension cable (not supplied).
LEDs are connected with a ribbon cable ( 50cm supplied with the card).

The card can be delivered as a bare card without any connection. Choose "bare card" if this options is required.

For more information see instruction LED-card.